“Hur Hur that’s what a timer on your phone is for dude”
Yeah but this was a smart plug that was going dusty in a drawer!
Anyway it’s not the notification that makes my brain tickle in that special way, but the fact that my HA takes note of who was in the kitchen when the air fryer was started and only notifies the floor with that person on when it’s done.
Now I’ve worked that logic out with a silly Air Fryer notification I can reuse it in all my other automations.
The secret is not caring it’s 4m away as long as it says you’re closest to that one. It’s not accurate, it’s a guess made with software.
As I’ve said I’ve sat at my PC on the front room and watched it say I’m in my bedroom and kitchen.
So for example my front room lights are based around an input boolean. They’re triggered on by motion but back off by whether the TV is on, my wife’s laptop is connected to the WiFi, the pc is switched off, and everyone’s presence is not in the front room. I already did all that and now I have presence as well.
It used to be that my wife would be sat there on her phone and the lights would go out, now because her phone is on her person they stay on.
Like I say, they’re not perfect but they are better than not having them.
I don’t think I’ll ever have my music follow me around the house.
Oh also try instead of basing automations around whether you are in a room, instead use “is not”
So for example when I get out of bed and get up for work by bedroom lights come on with my alarm. When I go downstairs and make a brew I am no longer in the bedroom so my automations turn off the lights in there. Is not “bedroom”
It’s triggered by the motion sensor outside my bedroom door, then it waits for my presence to be anything other than bedroom. Since I’m moving around the house it’ll trigger at some point.
Similarly my sleep automation turns off when the bedroom is no longer occupied. But that’s when my wife gets up 2 hours after me. It’s also triggered by motion, but then waits until my bedroom presence sensor no longer reads anything
Ah, ok… I see. I guess you’ve not filtering on distance then, ok. I see all my neighbours stuff on 1 sensor, so automatically started filtering (and then attempting to tune)
Good point on the negative room sensing, I think I need to start this again… but also ditch the crap module.
Thanks
Yeah you certainly need more than one sensor. I have one per floor
Yeah I have a million Bluetooth devices picked up but I’ve only put 4 of them so far into my Ha sensors. Fuck knows what the others are, but we have soany devices in the house that I can’t keep track, then there’s the neighbours’ stuff too…
Interestingly I stumbled across a YouTube short yesterday about hacking an android device from only knowing it’s Bluetooth Mac address, so theoretically I could really piss off my neighbours if they drove me to it.