As suggested already using manifolds with overflow smart splitters is the way I did it when I built a 10 heavy frame factory. The only place that hurt my brain was when I needed to split reinforced plate to 25 end points and there wasn’t enough volume for a manifold to work so I needed balancers and a 5 way balancer broke my brain. Doc in YouTube had the answer which is split into two, then split those two into three and feed one of the six end points into a merger before the split into two. Then the five remaining end points get the same treatment and you end up with 25 end points for heavy plate.

Good luck!

Yeah it was exciting… But we watch The Boys and Invincible together and so on. My kid knows when something is too much for them and to tap out.

We watched episode 1…!?

And my youngest is 19. I’m old.

Amazing compliment! Thank you. I’m humbled to hear that.

And maybe one day that’ll happen, when I retire or something?

In my youth. I just to do flip books and do on and had a digital Etch-A-Sketch that animated a few dozen frames I played with for years.

I’m thinking of doing a book for young children since my granddaughter was born earlier this year. I have an outline sketched out, contemplating doing that.

You nailed it!

Love the compliment, and a great flick! I need to watch it again.

Simple, peaceful, elegant. I love it!

Lol, thanks!

You too!

Thank you so much! I really love how it turned out. I loved the picture when we took it too so I’m a bit biased. My favorite spot in Yellowstone, even over the geysers.

Thank you!

Thank you!

Lol thank you! I keep staring at them too. Got lucky there.

Thank you! I really like how it turned out. I appreciate your advice!

Took your advice and others for this revision!

Took your advice and others for this revision!

Took your advice and others for this revision!

Thank you, fantastic advice!!

Oh that’s a fantastic idea! Would look more like some crap went down too that way. Thank you!