Gave it a shot (1472) but no luck.

Any suggestions on what to try?

Good question.

LAN device(s) pointed to WAN IP. LAN devices pointed to LAN IPs resolve fine and display webserver content. Cellphone (no WiFi) pointed to WAN IP does not exhibit the appended Opnsense webui port behavior.

I’m not sure what you’re suggesting but I am confident that IP Passthrough was set to DHCP Fixed on the BGW320-505 with the MAC of the Opnsense NIC before and after the Opnsense upgrade, if that helps.

So I’ve tried spinning up new turnkey containers for nginx to eliminate this as a potential issue. Everything can be accessed internally but new or old config alike, it’s the same inaccessible from WAN issue.

TP-Link Deco M5 x2. I have not mapped signal strength across rooms (mostly because their locations are hardstuck because of wiring limitations). Usually less than 20 clients (e.g., phones, tablets, a PC or two, IoT devices). Only 2 other networks sharing my channel (lowest available channel usage). 2.4 & 5 GHz. Walls are standard drywall with wood studs.

With 2 APs now, I’m usually seeing less than 80Mbps and range is poor (e.g., not even getting 5Mbps just two rooms away).

Usually seeing less than 80Mbps and range is poor (e.g., not even getting 5Mbps just two rooms away).

I’m down

So I’ve been patient (22 days have elapsed) but most of my communities still say this. I’m thinking it’s more than just a delayed sync issue at this point… Any suggestions?